Even in warm climate, tile and stone can feel uncomfortably cold. Easy Heat Warm Tiles Floor Warming Systems remove the chill with a gentle, continuous warmth. Warm Tiles may be installed directly over plywood, concrete or cement backer board substrates. The warming element rests in the mortar below your floor surface. Simple to measure, quick to install and easy to control, Warm Tiles are affordable luxury.
How do I know which floor warming system to buy?
The Warm Tiles Cable system provides unlimited design configurations for even the most difficult shaped room. The Warm Tiles cable allows you to install full floor warming coverage by lacing the cable on the floor wherever you require a heated area. Two different spacing options enable these extremely flexible cables to be installed virtually anywhere. In a typical room above a heated area, simply lace the cable 3”(7.61 cm) apart. For a room above an unheated area, on concrete slabs or a high heat loss room such as a solarium, alternate the spacing from 3”(7.61 cm) apart, then 1.5”(3.80 cm) apart, then 3”(7.61 cm) apart and so on. Simply lace the cable into the strapping included in your Cable Installation Kit and follow the Cable installation instructions. Choose the system that’s right for you!
Product Selection Chart for Cable Kits
Select Floor Warming kit voltage, 120V or 240V, to match your power supply. For areas larger than 70 ft2 (6.50 m2), the 240V kits may be more economical. Use Standard 3” (7.61 cm) spacing for rooms above heated areas. Use Alternate 3”, 1.5”, 3” (7.61 cm, 3.80 cm, 7.61 cm) spacing for rooms above unheated areas, concrete slabs or high heat loss areas. All measurements are per kit.
How do I know how much floor warming to buy?
There is no need to install floor warming systems under base cabinets or plumbing fixtures, within 2”- 8” (5.08-20.32 cm) of baseboards and 6” (15.24 cm) from the toilet flange.
• Accurately measure the length and width of the walkable heated areas of your room in sections, as shown on the Warm Tiles® room layout diagrams.
• Add the walkable heated areas together to determine the total square footage of floor warming that will be needed.
• Choose the correct system for your application by square footage from the Warm Tiles Product Selection Charts.
*Colored areas represent where you would install your Cable System.
A is 2'6" x 3' = 7ft2
B is (2'6" x 2') ÷ 2 = 2.5ft2
C is 3' x 5' = 15ft2
A + B + C = ft2 total walkable heated area
7.5 ft2 + 2.5 ft2 + 15 ft2 = 25 ft2 total heated area